If this cycle-time is suitable press and hold both
▲
and
▼
buttons for 3 seconds to enter it into the controllers
memory.
If the calculated cycle-time is not compatible with the
switching device press and hold the
✱
button then press
and hold
▲
or
▼
until a more suitable cycle-time is
displayed. Release the buttons, then press and hold both
▲
and
▼
buttons for 3 seconds to enter it into the
controllers memory.
Pre-Select Automatic Acceptance of Any Autotune
Cycle-time
Before selecting Autotune, enter program mode.
Select
CYC.T
Press and hold the
✱
button then press and hold
▼
until
indexing stops and
A - -
is displayed.
Note:
A - -
indicates that no cycle-time exists.
Press and hold
▼
to scroll to
TUNE
The controller will now alternately display
TUNE
and
oFF
. Press and hold the
✱
button and use
▲
to select
either
on
or
At.SP
. Release
▲
.
The controller will now run Autotune and will accept the
calculated cycle-time.
To Pre-Select Cycle-time Before Autotune
Before selecting Autotune, enter program mode.
Select
CYC.T
Press and hold the
✱
button, then press
▲
to increase
or
▼
to decrease the displayed cycle-time. Release
buttons when required value is displayed.
Select
TUNE
or index to another function then exit
program mode.
Proportional cycle-time
10
81
ON.OF
0.1
20
A --
Factory setting
ON/OFF
Autotune calculated
cycle-time
Manual settings
Seconds
✱ ▼
✱ ▲
Proportional Cycle-time (continued)
