DAMC-FMC2ZUP User’s Manual
Module Management Controller
23
3.
Module Management Controller
The MMC Stamp SoM implements standard MicroTCA module management as
well as the following additional features:
•
JTAG multiplexing
•
HPM update
•
Boot mode selection for both ZUP and Spartan-7 FPGAs
•
Interlock multiplexing
•
Auto-detection of variable FMC voltage (Vadj)
3.1
Serial Console
The MMC Stamp implements a command line interface on a serial port that’s
forwarded to the front panel USB connector. It uses VT100 escape sequences to
support convenience features like colors, autocompletion and shell history. To avoid
flooding "dumb" terminals with unsupported escape sequences, a fallback dumb
terminal mode is supported as well. This chapter lists some example commands, for a
full list see MMC command list.
3.2
JTAG multiplexing
The JTAG interface can be multiplexed between different sources and targets.
The JTAG signals on the on-board connector or the backplane can be routed to the
ZUP, the Spartan-7, the first or secondary FMC slot or the RTM.
Example command:
sj bp fpga1
will route JTAG from the backplane to the main FPGA.
Содержание DAMC-FMC2ZUP
Страница 14: ...DAMC FMC2ZUP User s Manual DAMC FMC2ZUP Architecture 14 Figure 2 1 Block Diagram...
Страница 19: ...DAMC FMC2ZUP User s Manual DAMC FMC2ZUP Architecture 19 Figure 2 2 Clock Network Diagram...
Страница 33: ...DAMC FMC2ZUP User s Manual Appendix 33 Figure 5 6 FMC connections...
Страница 34: ...DAMC FMC2ZUP User s Manual Appendix 34 Figure 5 7 FMC connections...
