CAENels DAMC-FMC2ZUP, Руководство пользователя

Страница: 32 / 34

DAMC-FMC2ZUP User’s Manual Appendix
32
5.3 MMC commands
The list of available MMC commands is shown in the following figure:
Command Arguments Description
? / h / help Show list of available commands
c Clear screen
r Reset MMC
v Show firmware version
xm [0..n] Start XMODEM update
sb Start bootloader
vb [0..6] Get/Set verbosity
tm [smart|bumb|auto] Get/Set terminal mode
s Get Status
lc [0..3] [on|off|blink] [on_ms] [off_ms] Set LED
ser [addr] [lun] Get/Set event receiver
pu Payload power up
pd Payload power down
pc Toggle CPLD programming / JTAG forwarding mode
sj [con|bp|raw] [fpga(1|2|12)|rtm|fmc(1|2)] Get/Set JTAG multiplexing
st [0..15] Get/Set RTM temp sensor mask
rte [enable|override] Get/Set RTM e-keying policy
cfu CPLD force update
fru [0..n] Dump FRU information
bz [jtag|qspi|qspi2|sd|pjtag|raw] Get/Set ZUP boot mode
b7 [jtag|spi|spi2] Get/Set Spartan-7 boot mode
rz Re-configure ZUP (PS_PROG)
r7 Re-configure Spartan-7 (PROG_B)
ci [out(0|1|2)|all] [rx19|tx19|rx20|zup|disabled|bypass] Get/Set interlock channel(s)
vc [low|high] Get/Set ZUP VCC_Core
fma [1|2|12] [8|16|auto] Get/Set FMC1/2 EEPROM address width
fmv [0.95..1.9|auto] Get/Set FMC VCC_Vadj
Figure 5-5: MMC Command Table
5.4 FMC/FMC+ connections
In the following figures are listed the connection to the FMC/FMC+ pins. For
detailed information regarding the FMC/FMC+ assignments, please refer to the BSP
(Board Support Package) project.