Document type:
Title:
Revision date:
Revision:
User's Manual (MUT)
A3486 3Phase 400Vac to 2x2kW/1x4kW 48Vdc
08/10/2007
10
NPO:
Filename:
Number of pages:
Page:
00120/04:A3486.MUTx/10 A3486_REV10.DOC
35
20
3. Safety information and installation requirements
3.1
General safety information
This section contains the fundamental safety rules for the installation and operation of the
boards. Read thoroughly this section before starting any procedure of installation or
operation of the product.
3.1.1
Safety Terms and Symbols on the Product
These terms may appear on the product:
•
DANGER
indicates an injury hazard immediately accessible as you read the
marking.
•
WARNING
indicates an injury hazard not immediately accessible as you read the
marking.
•
CAUTION
indicates a hazard to property including the product.
The following symbols may appear on the product:
DANGER ATTENTION
High Voltage
Protective Ground
Conductor Terminal
must be connected to
Earth Ground.
Refer to Manual
3.2 Injury
Precautions
Review the following precautions to avoid injury and prevent damage to this product or
any products connected to it. To avoid potential hazards, use the product only as
specified. Only qualified personnel should perform service procedures.
3.2.1 Caution
The following safety precaution must be observed during all phases of operation, service
and repair of this equipment. Failure to comply with the safety precautions or warnings in
this document violates safety standards of design, manufacture and intended use of this
equipment and may impair the built-in protections within.
CAEN shall not be liable for user’s failure to comply with these requirements.
To avoid electric shock or fire hazard, do not apply a voltage to a load that is outside the
range specified for that load.
To avoid electric shock or fire hazard, do not operate this product with covers or panels
removed.
Do Not Operate Without Covers.
To avoid electric shock or fire hazard, do not operate this product with covers or panels
removed.
