Problems on the Road
. . . 396
6. Attach the jack handle, exten-
sion and wheel wrench to the
jack.
Place the jack (with the wheel
blocks) under the vehicle
towards the front of the rear
bumper. Center the jack lift
point under the center of the
spare tire.
7. Turn the wrench clockwise to
raise the jack until it lifts the
end fitting.
8. Continue raising the jack until
the spare tire stops moving up
and is held firmly in place.
The secondary latch should
release.
The spare tire is now balancing
on the jack.
9. Lower the jack by turning the
wrench counterclockwise.
Keep lowering the jack until
the spare tire slides off the jack
or is hanging by the cable.
CAUTION
If the spare tire does not slide
off the jack completely, make
sure no one is behind you or on
either side of you when you pull
the jack out from under the
spare. Someone standing too
close during the procedure
could be injured by the jack.
$10araEscaladeEXT Page 396 Wednesday, October 14, 2009 9:54 AM