Cabletron Systems KBU 64, Руководство пользователя

Страница: 48 / 127

KBU 64
User Manual
80-10100000-09 4–6
You can alter the default configuration settings. These alterations take
immediate effect, and are automatically stored in battery backed RAM,
remaining in memory during a power failure or when powering down the
KBU 64.
4.4.1 Reset On Power-up to Default Configuration
Is achieved by powering up the KBU 64 while holding the left hand
Backup button depressed. This will reset your unit to its factory default
state (as supplied). This action also clears the non-volatile RAM of any
altered data.
The COMMAND port and ALARM port will revert to factory set
configurations.
4.5 Altering/Defining a Configuration Parameter
Setting
The SET command must be used as a prefix to all configuration
commands. For example:
1> SET BACKUP AUTO
[CR]
Because this command is entered following the
1>
prompt, it will only
take effect on channel 1 of your KBU 64 (the USER 1 to LINK 1
Kilostream line). If a similar setting is required on channel 2, then the
command line must be repeated at the
2>
prompt.
If you omit the SET command, an error message will be displayed.
4.6 Enabling/Disabling the KBU 64 Help Messages
Your KBU 64 software is equipped with many HELP messages that can
be displayed at the terminal. These are designed to be informative and
to offer guidance to the required syntax and available parameters of any
given command.
The HELP facility is normally enabled (default state), but it can be
disabled (or re-enabled) by software command. Help messages are only
ever displayed when a syntax error occurs in a command line.