Wide Area - 1 and 2 Configuration Windows
QuickSET Configuration Guide
79
Protocol —
Displays the active protocol for the Wide Area interface. The Protocol panel lets you
select one of four protocols: Point-to-Point, HDLC (High Level Data Link Control), Frame Relay
Point-to-Point, Frame Relay Point-to-Multipoint.
High Level Data Link Control lets you select either Full or Fractional mode for all or half of the
time slots (for a single interface number and alias). Point-to-Point protocol lets you select an
interface number for each time slot. Frame Relay Point-to-Multipoint allows only one interface
number and alias, but allows multiple DLCIs. Frame Relay Point-to-Point allows multiple
interface numbers, aliases, and DLCIs.
Link Management Protocol —
If you selected Frame Relay protocol, this field displays Q.933
Annex A, T1.617 Annex D, and T1.617 Annex D 1994. The default is T1.617 Annex D. When you
have completed Wide Area DI configuration, click on the Next>> button, and go to the
Wide Area
Frame Relay Time Slot Configuration Window
or the
Wide Area PPP Time Slot
Configuration Window
section.
DLCI Setup Button
The DLCI Setup button displays the DLCIs window shown below in
Figure 86
. The DLCIs
window shows a list of Interface Numbers, Aliases, and DLCIs (Data Link Connection Identifiers).
Use the Add button and the Add DLCI window to make new entries to this table. Use the Delete
button to delete the entry highlighted. Click Done when you have finished.
Figure 86 DLCIs window and Add DLCI window
When you have finished, click on the Next>> button, and go to the
Wide Area Time Slot
Configuration Windows
section, for the appropriate time slot window.
