Wide Area Module Configuration
QuickSET Configuration Guide
19
DDS Loop Back —
Displays the internal loopback as either Line Loop or No Loop. Line Loop is
reserved for network diagnostics only. The default setting is No Loop.
Protocol —
Displays the active protocol for the Wide Area interface. The Protocol panel lets you
select either Frame Relay or Point-to-Point.
Link Management Protocol —
If you selected Frame Relay protocol, this field displays
Q.933 Annex A, or T1.617 Annex D. The default is T1.617 Annex D. This field is grayed out and
not used for PPP.
When you have completed Wide Area DDS configuration, click on the Next>> button, and go to
the
General Configuration
section of this guide
Wide Area HDSL Configuration Window
The Wide Area HDSL configuration window is shown in
Figure 16
, below.
Figure 16 Wide Area HDSL Configuration Window
This section describes the fields in the Wide Area HDSL configuration window.
HDSL Transmit Clock Source —
Displays the HDSL Transmit Clock Source. Click on the radio
button to select either the Slave or Master option. The default setting is Slave.
Protocol —
Displays the active protocol for the Wide Area interface. The Protocol panel lets you
select either HDLC or Point-to-Point [currently only Point-to-Point is supported].
When you have completed Wide Area HDSL configuration, click on the Next>> button, and go to
the appropriate window in the
Wide Area Time Slot Configuration Windows
section, which
follows.
