CAB 4114 Series, Руководство по обслуживанию

Страница: 20 / 44

20 20
7.1 Pad Adjustments
For optimal functionality it is necessary to place the pad exactly over the label for the takeover procedure.
Moving the pad in X-, Y- and Z-direction
6
1 mm
1 mm
7
1
3
2
4
5
Fig. 14 Moving the pad assembly
Adjustment in the X-direction - Sideways Adjustment
1. Loosen screw (3).
2. Move the cylinder assembly group (4) including pad along the cross beam until the pad is over the middle of
the label intended for application. For better orientation there is a graduation mark (5) depicted on the assembly
group.
3. Tighten screw (3).
Adjustment in the Y-direction - Print Direction
1. Loosen screws (1).
2. Move cylinder assembly (4) including pad along the guide rail so that the distance between the edge of the pad
(6) and the edge of the dispense plate (7) of the printer is approximately 1 mm.
3. Tighten screws (1).
Adjustment in Z-direction - Height Adjustment
1. Loosen screw (3).
2. Turn setting screw (2) so that the bottom of the pad is 1 mm over the top edge of the dispense plate (7).
3. Tighten screw (3).
Adjusting the Parallelism between Pad and Dispense Edge
The edge of the pad must be parallel to the dispense edge of the printer.
11
10
8 9
3 4
6
7
Fig. 15 Adjusting the pad to the dispense edge
1. Loosen knurled screw (10) and screw (9).
2. Press the applicator against the printer and adjust the angle between applicator pad edge (6) and printer
dispensing plate (7) via the setting screw (11) and the eccentric (8).
3. Tighten screw (9) and fasten the applicator with knurled screw (10).
7 Adjustments
y
x
z
y
x
z