C.Plath NAVIGAT X MK 1 Mod. 10, Руководство оператора

Страница: 41 / 82

Page 4-11
NAVIGAT X MK 1 Mod. 10 / SR-180 MK 1 Mod. 10
056310
3-149 MK110ENG.P65
Only when a complete baseplate assembly is to be exchanged, a new
correction angle must be entered. Each baseplate carries a label indi-
cating the required shaft encoder correction angle.
4.6.8 Ext. Status Input
Settings: Status LOG = log status
Status HDG +180° = turn heading display by 180°
Function: Selects the function to be activated via the external status input. If set
to LOG, the external status input reads the status signal from a pulse
log. If set to HDG +180°, the heading display can be turned by 180°
using an external selector switch (e.g. for operation in ferries).
4.6.9 Name of Gyro
Settings: gyro ID: 1/2/3
Function: Sets the compass' ID. The ID serves to identify the individual gyrocom-
passes in multicompass systems.
4.6.10 Test Mode
Settings: rate of turn: -99.9°/min – +99.9°/min
scale factor: 0.1 – 99.9 mV
heading: 0.0 – 359.9°
Function: The test mode serves to test the proper function of the analogue rate of
turn output and of the serial and 6 step/° outputs.
In test mode operation, an output voltage corresponding to the set rate
of turn and scale factor is present at the analogue rate of turn output.
After initiation of the test mode, the heading data sent to the serial and
6 step/° outputs moves from the actual to the set value with the set rate
of turn.
The test mode is activated once the user has set a value in the test
mode sub-menu. The test mode is quit by leaving the test mode sub-
menu.
Note: The test mode provides a convenient method of setting the scale factor
of an analogue rate of turn indicator:
Set the rate of turn to a suitable value and adjust the scale factor until
the rate of turn displayed on the indicator matches the set value.