C.Plath NAVIGAT X MK 1 Mod. 10, Руководство оператора

Страница: 40 / 82

Page 4-10
NAVIGAT X MK 1 Mod. 10 / SR-180 MK 1 Mod. 10
056310
3-149 MK110ENG.P65
Note: Feedback signals are only read to record the rudder angles using the
voyage data printer NAVIPRINT. No rudder angle data is sent to the
serial outputs.
If the number of rudders is set to 2, NAVIPRINT automatically prints
two rudder angle graphs next to each other.
4.6.5 System Type
Settings: G = single gyrocompass
GM = single gyro- and magnetic compass
GG = twin gyrocompass
GGM = twin gyro- and magnetic compass
Int/G = internal switchover, single gyrocompass
Int/GG = internal switchover, twin gyrocompass
Ext = external switchover via selector switch
NSD = internal switchover w. NSD-protocol evaluation
Function: Selects the compass system type and the heading reference switchover
mode.
Note: According to the system type settings, unused heading data inputs
must be inactivated in the interface configuration.
In twin gyrocompass systems, different compass IDs must be assigned
to the individual compasses (see 4.6.6).
4.6.6 Alignment Error Correction Value
Settings: -180.0° – +180.0°
Function: Sets the alignment error correction to the required value. Alignment
error is 0° if the sides of the compass housing are running exactly par-
allel to the vessel's longitudinal axis and the back of the housing points
dead ahead. The required correction value equals the alignment error
with the sign reversed.
Note: After correction of the alignment error, the gyrocompass is to display
the angle between the vessel's longitudinal axis and true north to 0.5°.
4.6.7 Shaft Encoder Correction Angle
Settings: -180.0° – +180.0°
Function: Sets the shaft encoder correction to the required value. The shaft en-
coder correction angle is set in the factory and must not be changed.