Configuration Backup and Restore
UM1600-2-A 2002
132
configuration:
Step 1: Open a terminal emulation interface in order to execute CLI.
Step 2: Enter the command “upgrade enable” in Command Line Interface
for executing TFTP to IPAM-1600s.
Example
SmartDSLAM# upgrade enable
Yes or No <y/n>? y
System is in the “upgrade” mode now. You could start to upgrade the
system file.
Note:
This step can be skipped, in case of without Ethernet-VLAN on each port.
Step 3: Enter the command “ show sysip” to get the <IP address> of
IPAM-1600s. If you already know the IP address, you can skip this
step.
Example
SmartDSLAM# show sysip
IP: 192.168.10.2
Submask: 255.255.255.0
Gateway: 192.168.10.1
Note:
Make sure that the system IP and your computer is in the same subnet.
Step 4: Open another window interface, e.g., MS-DOS interface.
Step 5: Enter the command “tftputil <IP address> <get> <sf_user.cfg>”
under the directory of configuration file and control files.
Example:
c:\> tftputil 192.168.10.2 get sf_user.cfg
When uploading, three LEDs, “MAINT” “ALARM” and “FAULT”, will blink. Unless
you finish uploaded, do not shut down ADMS-L231 and unlink cat 5 cable.
Step 6: Restart the system in terminal emulation interface. The system will
restart according to your “sf_user.cfg”.
Example
SmartDSLAM# restart
Yes or No <y/n>?
System is restarting now.Wait…..
Содержание IPAM-1600s Series
Страница 1: ...I IP PA AM M 1 16 60 00 0s s Standalone 16 Ports IP DSLAM USER S GUIDE DOCUMENT NO UM1600 2 A 2002...
Страница 21: ...Introduction UM1600 2 A 2002 19 Fig 1 5 IPAM 1600s Ethernet All the Way Application...
Страница 141: ...Appendix A UM1600 2 A 2002 139 8 PHONE 8 T 33 PHONE 8 R 9 25 34 50 Note Connector type is 50 pin teleco champ female...
Страница 142: ......