18
Regulation of the motor thrust (PMOT)
The force applied is normally set automatically by the control unit during the self-regulation phase (AUTO).
This menu can be used to modify that set by the control unit, to make up for a friction point for example.
1
Press the [PGM] button to access programming or if the control unit is already in the programming
menu, press [
5
] until the PMOT function is displayed.
PMOT
pmot
PMOTPMOT
2
Press the [PGM] button to enter the PMOT regulation.
The display shows the current value of the PMOT parameter.
Use the [
5
] key to select one of these values:
1 low motors torque
2 medium/low motors torque (default setting)
3 medium/high motors torque
4 high motors torque
0001
0004
3
Confirm the desired value using the [PGM] key, the display shows PRG.
PRG
4
To go back to the programming menu, press the [PGM] and [
5
] buttons at the same time.
To exit programming, remove the power supply or wait for 60 seconds.
PGM+
5
Regulation of the automatic closure time (TCA)
The automatic closure function allows to set a time, which, on expiry, if the leaf is in the open position the control unit autono-
mously commands a closure manoeuvre.
With this function active, if you forget to give the closure command or in the case of simultaneous commands, the control unit
closes the leaf after the set time.
The factory setting envisions 30 seconds before automatic closure.
1
Press the [PGM] button to access programming or if the control unit is already in the programming
menu, press [
5
] until the TCA function is displayed.
TCA
2
Press the [PGM] button to enter the TCA parameter regulation.
The display shows the current value of the TCA parameter.
Use the [
5
] key to select one of these values:
0 The TCA function is deactivated.
1 The pause time is set at 10 seconds
2 The pause time is set at 30 seconds (default setting)
3 The pause time is set at 60 seconds
4 The pause time is set at 90 seconds
0000
0004
3
Confirm the desired value using the [PGM] key, the display shows PRG.
PRG
4
To go back to the programming menu, press the [PGM] and [
5
] buttons at the same time.
To exit programming, remove the power supply or wait for 60 seconds.
PGM+
5
Содержание BEAUTY
Страница 27: ......
