17
Self-regulation of the functioning parameters (AUTO)
The first and most important function to program is the self-regulation of the parameters, which allows the control unit to auto-
matically set the end run points, the torque applied to the leaf and the slowing phases*.
During the autoset operations, the control unit automatically performs several opening and closure manoeuvres.
Before proceeding, check that no person, animal or obstacle is or can be in the door manoeuvre area.
Proceed as follows:
1- Apply mains power supply to the automation via the pre-wired socket, using an extension if necessary.
2- Release the leaves, take them manually to about half of the run and block them again.
3- Start the autoset phase as described below. As soon as the first manoeuvre starts, carefully check that:
a) both leaves must move in the closure direction.
If this is not the case, press “5” and “PGM” at the same time to interrupt the autoset. The display shows the ERR message.
Invert the M+/M- wires of the motor/s that moved in the opening direction.
b) the first motor to perform closure must be that connected to clamp M2. If this is not the case, invert the connections of mo-
tors M1 and M2.
1
Apply mains power supply by connecting the plug
2
Press the button [PGM] to access programming.
PGM
3
The display shows AUTO, select Auto by pressing the [PGM] button.
AUTO
4
AUTO starts to flash slowly. Press and hold the [PGM] key, after 5 seconds AUTO starts to flash
quickly, release the key only when the display shows the PRG message.
5
The self-regulation phase starts, the display shows PRG. The control unit commands different open-
ing and closing manoeuvres at various speeds.
At the end of the manoeuvre the display shows “OK”
PRG
6
To go back to the programming menu, press the [PGM] and [
5
] buttons at the same time.
To exit programming, remove the power supply or wait for 60 seconds.
PGM+
5
* The slowing phase envisions that the last phase of manoeuvre, both opening and closure, are performed at a slower speed,
thus allowing a silent manoeuvre.
The intervention of the photocells or any other command from the transmitter or key selector, interrupts the autoset
phase, displaying the message ERR1/2/3. The procedure must therefore be repeated.
Every self-regulation procedure overwrites the previous one.
Perform an autostop procedure after every maintenance intervention or modification of the door
.
Programming of the control unit allows the regulation of all
parameters indispensable for the correct functioning of the
automation.
Programming takes place by means of a series of menus that
can be selected from the LCD. A function corresponds to every
menu, which will be described successively.
PGM
The “PGM” button allows to enter programming,
select the pre-selected menu and confirm the
value selected.
5
The “
5
” button allows to scroll the various items in
the menu and the values to be set cyclically.
PGM+
5
By pressing “
5
” and “PGM” at the same time,
return to the upper level of the menu or, if already
at the first level, exit programming.
Programming the CP.JMP control unit - Introduction
LCD
PGM
With the display off, the “
5
” button performs a Step-
by-Step command. This function can be useful during
the programming and inspection phases.
Содержание BEAUTY
Страница 27: ......
