BYD G3 AUTO, Руководство пользователя

Страница: 50 / 160

BYD G3 AUTO Owner’s Manual
44
Remove the fill cap of cleanser tank, and
check the cleanser level on the fluid
level gauge If the level is near “LOW”
mark, please add cleanser until it
reaches “HI” mark on the fluid level
gauge.
The cleanser added shall be
windshield glass cleanser, if it is not
available you can use clean water as
substitute. But in cold region you shall
use windshield glass cleanser with
anti-freezing agent It is available in BYD
service stations and most auto part
stores. For mixing ratio of water and
anti-freezing agent, please refer to
manufacturer’s instructions.
Note
Please adjust the concentration of
the cleanser according to the
external temperature. With improper
concentration, the cleanser may
freeze on the windshield and affect
the driver's view, and the cleanser in
the tank may also freeze.
Do not use engine cooling fluid as
cleanser, which may cause damage
to the paint of the car.
Rear Windshield Defroster
To remove fog or frost on the rear
windshield, please press this switch.
The ignition switch shall be on “ON”.
The slim heating wire at the internal side
of the rear windshield will make the
glass clear quickly. The indicator will be
turned on, indicating that the defroster is
in working.
Press the switch again and the defroster
will be turned off.
When an auto AC controller is installed,
the system will be turned off
automatically after the defroster
operates for some 15 minutes.
After the rear windshield becomes clear,
make sure to turn off the defroster.
Leaving defroster operating for a long
time will cause discharge of battery,
especially when the car is stopped
frequently. Defroster is not intended to
remove rain and snow.
Note
◆ When manual AC controller is
installed: to prevent battery
discharge, turn off the defroster
switch when stopping the
engine.
◆
When clean the internal side of
the rear window, pay attention
to not scratching or damaging
heating wire or its connector.