BYD ECB70, Руководство оператора

Страница: 20 / 23

ECB70 / 80
39
OM-ECB70 / 802019001-EN
OPERATOR MANUAL
38
OM-ECB70 / 802019001-EN
3.Adjustment Order
2-stage mast:
(1)Clearance between the outer mast and the inner mast.
(2)Clearance between the inner mast and the carriage.
3-stage mast:
(1)Clearance between the outer mast and the middle mast.
(2)Clearance between the middle mast and the inner mast.
(3)Clearance between the inner mast and the carriage.
Hydraulic System Maintenance
Hydraulic Oil Filling
1.Park the forklift on the level floor and apply the handbrake, remove the key, press down the
emergency disconnect switch and open the seat cover fully.
2.Open the seat cover plate completely to observe the oil level gauge.
3.If there is no hydraulic oil in the oil level gauge, open the top cover of the return oil filter and
add oil.
Caution
1.While adding oil, be careful to prevent dust and water from entering the oil tank.
2.Do not mix different types of hydraulic oil.
3.When disposing the waste oil, keep children away and do not pour it into the sewer or onto
the ground.
4.Using unauthorized hydraulic oil might cause damage to hydraulic system. Use only authorized
hydraulic oil. If you need to switch to other types of hydraulic oils, contact with the BYD forklift after
sales service people.
Hydraulic Oil Replacement
1.Drive the forklift to the maintenance ditch, switch off the handbrake, remove the key and press
down the Emergency Disconnect Switch.
2.Fully lower the forks, apply the hand brake, and place a container below the oil drain of the
tank. Unplug the oil drains plug at the bottom of the oil tank and drain the hydraulic oil.
3.Before putting the plug back on, make sure that the seal ring is complete and intact and then
secure the plug.
4.Add a small amount of hydraulic oil first to check if the seal ring on the drains plug is OK.
Tighten the plug if oil leakage occurs.
5.Add hydraulic oil into the oil tank and measure the oil level with the dipstick.
6.Remove and clean the residual oil spill on the oil tank and forklift bottom and working area.
Caution
1.While adding oil, be careful to prevent dust and water from entering the oil tank.
2.Do not mix different types of hydraulic oil.
3.When disposing the waste oil, keep people away and do not pour it into the sewer or onto
the ground.
4.Using unauthorized hydraulic oil might cause damage to hydraulic system. Use only
authorized hydraulic oil. If you need to switch to other types of hydraulic oils, contact with the BYD
forklift after sales service people.
Return Filter Element Replacement
1.Park the forklift on a level ground and fully lower the mast and apply the parking brake. Take
off the key, press down the emergency disconnect switch and open the seat cover fully.
2.Put the clean cloth around the return filter.
3.Unscrew the filter bowl and pull the out filter element.
4.Clean the cover plate and check if the seal and the O-ring are in good condition, replace
them if necessary.
5.Check if the spread and the O-ring of the new element are in good condition, replace them if
necessary.
6.Use clean hydraulic oil to lubricate the O-ring of the new element, fit the new element
carefully and screw the cover plate.
7.After replacement, operate the hydraulic system to check if there is any leakage.