BYD ECB70, Руководство оператора

Страница: 14 / 23

ECB70 / 80
27
OM-ECB70 / 802019001-EN
OPERATOR MANUAL
26
OM-ECB70 / 802019001-EN
Transporting Loads
Loading
Load on the ground:
1.Drive the forklift carefully up to the load and brake the forklift to a stop.
2.Lower the forks on the floor.
3.Insert the forks under the load.
4.Lift the forks.
5.When transporting, drive with caution, pay attention to the route condition and to the people
ahead and maintain a proper driving speed. Transport the load to the designated place.
Load on the high shelf:
1.Drive the forklift carefully up to the load and brake the forklift to a stop.
2.Set the mast in the vertical position and raise the forks to the bottom of the load.
3.Insert the forks under the load.
4.Raise the load until it has left the shelf completely.
5.Reverse the forklift with caution at a low speed until the forklift leaves the stacking area.
6.Lower the forks.
7.When transporting, drive with caution, pay attention to the route condition and to the people
ahead and maintain a proper driving speed. Transport the load to the designated place.
Danger
1.When approaching the load, do not travel at high speed to avoid crashing.
2.Do not stay beneath the raised load.
Caution
When transporting the load, the load should be securely fastened on a pallet with the gravity
center well centered and with the proper stacking height. Do not damage the packing of the load.
The operator should be held responsible for the safe loading and unloading.
Travelling
1.When travelling with load, make sure that the load is well centered on the forks.
2.After the load is placed on the forks, keep the mast tilted backwards and raise the forks
above the floor.
3.During the travelling of the forklift, do not try raising the forks to avoid the danger of forklift
nose over and losing stability.
4.If the stacked loads are high and affect the operator’s visibility of the route ahead, operate
the forklift in reverse except when the forklift is climbing the slope or inclines.
Warning
1.When driving the forklift on a slope, keep the forks always facing the uphill direction and
drive in turtle speed mode when facing the downhill direction.
2.Do not cross or turn around on a slope.
Caution
1.Have a second person as lookout if the visibility of the operator is reduced.
2.Do not depress the brake pedal with a lot of force, since excessive force might cause
damage to the braking system.
Unloading
1.Drive the forklift carefully up to the stacking destination and decelerate when approaching.
2.Raise the forks to the proper height.
3.Drive the forks and load into the shelf.
4.Set the mast in the vertical position and lower the forks to the proper height until they get
separated from the forks.
5.Slowly remove the forks from the bottom of the load.
6.After driving the forks out, raise them and start the next.
Exiting from the Forklift
1.Lower the forks after unloading.
2.Turn the key anticlockwise to OFF position and take it out.
3.Pull off the hand brake.
4.Exit from the forklift.