Operation
Now that the appliance has been prepared for our intended use, we can set it up
for operation.
1.
Find a suitable sturdy, non-combustible vertical surface to hang the appliance. The
surface should be at least 1000mm clear from the sides and 1000mm from the top of all
combustible surfaces, fabrics, flammable materials & people.
Hang the appliance on a suitable vertical surface by the top hanger attached to the
back cover of the heater.
The appliance is ready to be connected to gas and water hoses.
6.
It is preferable to set the Heat Setting Control to LOW
Our heater is now set up and ready for use. Notice: the positioning of the gas
cylinder away and to the side of the appliance; never place the gas cylinder
directly beside or above the appliance.
2.
Connect the Gas Hose to the POL Propane gas cylinder. Hand-tighten the
connection in an anti- clockwise direction.
Open gas tap on cylinder one full turn, and then check the connections for
leaks with soapy water.
DO NOT use a flame.
If a leak is detected, turn the cylinder valve off (close),
check seals and retighten all connections and retest.
4.
Once you determine that there are no leaks present with the gas valve open,
turn the cylinder valve to the off (close) position.
5.
Connect water supply by either pump supplied or alternate pressurised
water source.
Gas Hose
and Regulator
Shower Hose
3. IMPORTANT
| Gas Hot Water Shower
|Gas Hot Water Shower
Page 11
Page 12
Содержание 78X04
Страница 1: ...78X04 ...