Burstner I 2012, Инструкция по эксплуатации

Страница: 73 / 292

73
I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Living
6
6.7.3 Holder with jointed arm
The flat screen is fastened to a jointed arm.
Positioning:
„
Pull the release knob (Fig. 74,3). The jointed arm (Fig. 74,4) is unlocked.
„
Swivel flat screen into the desired position.
„
Take hold of the flat screen at the top and bottom edge with both hands and
set the desired angle of inclination.
Storing away:
„
Turn the flat screen back into the original position until the holder
(Fig. 74,1) engages in the lock (Fig. 74,2).
6.8 Ventilation
Condensation Ensure that there is a continuous exchange of air by providing frequent and
efficient ventilation. This is the only method for ensuring that condensation and
resulting mould is not formed during cool weather. During the colder season,
a pleasant living climate is created if heating output, air distribution and venti-
lation are synchronised. To avoid draft close the air outlet nozzles on the dash-
board and set the air distribution of the base vehicle to air circulation.
If the vehicle is laid up for a longer period, occasionally ventilate it well, espe-
cially in summer as heat accumulation can occur. Do not only air the interior,
but also the storage compartments which are accessible from the outside. Air
the parking place as well if the vehicle is parked in a closed space (e.g.
garage). The occurrence of condensation could lead to the formation of mould.
Fig. 74 Holder with jointed arm
X
The oxygen in the vehicle interior is used up by breathing and the use of
gas operated appliances. That is why the oxygen needs to be replaced
on a constant basis. For this purpose, forced ventilation options (e.g.
skylights with forced ventilation, mushroom-shaped vents or floor vents)
are fitted to the vehicle. Never cover or block forced ventilations from the
inside or outside with objects such as e.g. a winter mat. Keep forced ven-
tilations clear of snow and leaves. There is a danger of suffocation due
to increased CO
2
levels.
Z
Although sufficient ventilation is provided, in certain weather conditions,
condensation can form on metal objects (e.g. screwed connections in the
floor).
Z
Additional cold spots can occur at thermal "bridges" (e.g. mushroom-
shaped vents, skylight edges, sockets, filler necks, flaps, etc.).