Burstner I 2012, Инструкция по эксплуатации

Страница: 53 / 292

53
I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Pitching the motorhome
5
Extending:
„
Press the push button for approx. 2 seconds until a brief sound is emitted.
The steady legs control is now activated.
„
Press and hold the preselection button for the steady leg side (Fig. 36,2
or 4) for approx. 1 second.
„
Within 2 seconds, press the "Extend steady leg" button (Fig. 36,3) and hold
it until the support leg (Fig. 37,4) is touching the ground.
„
Press the preselection button for the other steady leg side and repeat the
procedure.
Retracting:
„
Press the push button for approx. 2 seconds until a brief sound is emitted.
The steady legs control is now activated.
„
Press and hold the preselection button for the steady leg side (Fig. 36,2
or 4) for approx. 1 second.
„
Within 2 seconds, press the "Retract steady leg" button (Fig. 36,1) and
hold it until the support leg (Fig. 37,4) is fully retracted. Once the support
leg is fully retracted, a control signal sounds.
„
Press the preselection button for the other steady leg side and repeat the
procedure.
Changing the remote
control battery:
„
Remove the rear casing.
„
Change the battery (CR2032). Observe the correct polarity ("+" to the out-
side).
Emergency operation If the electric drive breaks down, the steady legs can be moved with the hand
crank.
Extending/retracting:
„
Press the securing bracket (Fig. 37,2) inwards.
„
Push the motor (Fig. 37,3) in the direction indicated as far as it will go.
„
Extend or retract the steady leg like a mechanical steady leg via the hex-
agonal nut (Fig. 37,1).
When the fault has been rectified: Push the motor in the opposite direction of
the arrow to its initial position. Pull out the securing bracket (Fig. 37,2) until it
engages.
5.6 230 V connection
The vehicle can be connected to a 230 V power supply (see chapter 8).
Z
Do not extend the steady leg to the end position without it being in contact
with the ground.
Z
The battery must be changed if the control LED flashes more slowly or if it
goes out.
Z
Further information can be obtained in the manufacturer's instruction
manual.