Burster 9180, Руководство пользователя

Страница: 61 / 109

burster
Digital Panelmeter
Model 9180
Page
M
A
X
M
I
N
1
HOLD
TARA
2
TARE RESET
ESC
LIMIT MAX/MIN
DATA
ENTER
3
4
4-17
4.2.6 Setting limit values
Definition
The flow chart on page 4-16 (programming instructions) corresponds to module 30 for programming
switching points for equipment versions 9180-VXXX1, 9180-VXXX2 and 9180-VXXX3. If you
only have the option with 2 relays (9180-VXXX1) at your disposal, only menus 31 and 32 appear
for switching points
SET1
and
SET2
.
Each switching point is programmed individually. If the programming of a switching point is
completed, you can again access module 30 by pressing the "
ENTER
" key again (the message
-Pro- appears in the secondary display) to configure the remaining switching points.
The flow chart shows that the switching points
SET1
and
SET3
are activated independently of
each other, while switching points
SET2
and
SET4
can be activated in isolation as well as in
mutual dependency. In this case
SET2
is dependent on
SET1
and
SET4
is dependent on
SET3
.
Switching point 2 is also equipped with an automatic track function.
Access to programming the switching points
Press " ENTER " to go from the operating mode to the programming mode. Press the " " three
times to reach level 30 Fig. 4.2.6a.
Fig. 4.2.6a
Information regarding the program flow chart (Page 4-16)
As programming of the 4 switch points (page 4-18) as independent alarms is identical, the
numbers of the switch points in the figures were replaced by the symbol "
#
" so that these steps
apply for all switching points.
When programming switching points 2 and 4 the options "ON" or "TRAC" (see Fig. 4.2.6c) lead
to different subroutines. Each of these programs is dealt with individually on page 4-18.
Press "
ENTER
" again and the message "
31-
SET1
" appears in the display for entry into
the programming menu switch point 1. You
are now on the switch point selection level.
By pressing "
" you can configure the next
switching point.