Burster 9180, Руководство пользователя

Страница: 34 / 109

Model 9180
burster
Digital Panelmeter
Page 2-22
Climbing meas. range Falling meas. range
DISPLAY1
(dSP2)
DISPLAY2
(dSP2)
INPUT2
(InP2)
1
2
INPUT1
(
I
nP1)
DISPLAY2
(dSP2)
DISPLAY1
(dSP1)
INPUT1
(
I nP1)
1
2
INPUT2
(
I nP2)
When programming the measurement range, first the input and output parameters are entered
in accordance with point 1, then the decimal point and finally the input and output parameters
corresponding to point 2.
When programming the input the decimal point is automatically set to the position which permits
the largest possible display. However, this can be adjusted manually.
The position of the decimal point must always be selected (equally applicable to both
DISPLAY1
and
DISPLAY2
) so that the best possible resolution is attained.
The instrument provides two programming methods:
SCAL
and
TEACH
.
The
SCAL mode
permits the entry of 5 parameters, 2 input values (
INP1
,
INP2
), the corresponding
display values (
DSP1
,
DSP2
) and the position of the decimal point. This is a very precise manner
of calibrating, if the output signals of the sensors are known exactly.
In
TEACH mode
you need to know which signal the sensor supplies. After connecting the sensor
select the
TEACH
function after reaching programming routine 20
CNfdSP
. After pressing the
ENTER
button
22-tCH1-
appears and the sensor needs to shed its load or supplies a zero signal.
Press
ENTER
again and then enter the
ZERO POINT POSITION
. Place the decimal point at the
correct position and confirm with
ENTER
.
22-tCH2-
appears in the display. Now set your sensor
to nominal load or the end range and confirm by pressing
ENTER
. Now enter the end range for
the display and finish the routine by pressing
ENTER
. Pressing
ENTER
again stores the data.