Burley ASTUTE G4113, Инструкция по установке, обслуживанию и эксплуатации

Страница: 4 / 28

3
Battery Replacement
Handset
1.1 On the back of the handset remove the battery cover by pressing down the top of the cover
& sliding it down.
Remove & unclip the old battery & replace with a new PP3 9 volt battery.
Receiver Unit (located under burner)
Remove the heat shield surrounding the unit. Pull the receiver unit out from underneath the
burner & remove the top cover. Remove old batteries & replace with four new AA batteries
ensuring the polarities are correct. Replace the battery cover & return the receiver unit to its
original position. REPLACE THE HEAT SHIELD over the unit.
CAUTION: With the exception of battery replacement, the
battery holder must be located within the heat shield at all times .
Pairing Handset to Receiver
If for some reason the remote handset requires re-programming to operate the receiver follow the
procedure below:
1. Press and hold using a pointed object the receiver’s reset button until you hear two acoustic signals.
2.
After the second longer acoustic signal, release the reset button and within the subsequent 20
seconds, press the (small flame) on the remote handset until you hear an additional long acoustic
signal confirming the new code is set.
RESET