Burford 2200M, Руководство пользователя

Страница: 142 / 214

138 Chapter 7
Mechanical troubleshooting, cont’d.
Problem
Description
Probable Cause Recommended Action
Twist tie ribbon breaks
during tying operation.
1. Excessive ribbon tension. 1. See pg.71 for proper tension adjustment.
2. Poor quality ribbon.
2. Replace ribbon.
3. Poor bag tail
presentation.
3. Bag tail presentation from the exit of the bagger must be
flat and not folded over. If this is not achievable, contact
your Bagger manufacturer for assistance.
Ribbon wraps around
twister hook shaft.
1. Twister hook shaft is too
close to holder shear.
1. Move hook shaft to proper spacing.
2. Poor bag tail
presentation.
2. Bag tail presentation from the exit of the bagger must be
flat and not folded over. If this is not achievable, contact
your Bagger manufacturer for assistance.
Twist tie ribbon breaks
during tying operation.
1. Excessive ribbon tension. 1. See pg. 71 for proper tension adjustment.
2. Poor quality ribbon.
2. Replace ribbon.
3. Poor bag tail
presentation.
3. Bag tail presentation from the exit of the bagger must be
flat and not folded over. If this is not achievable, contact
your Bagger manufacturer for assistance.
Excessive Belt Motor
fuse failures on AMP
board.
1. Excessive belt tension.
1. Check tension of all three belts driven by belt motor.
Correct as necessary.
2. Foreign material jammed
in tyer.
2. Clear foreign material.
Ties are not centered
on product.
1. Bag tucked into itself
caused by excessive air
jet blowing bag away from
scoops on Mark 50 type
bagger.
1. Reduce strength of air jet.
2. Tyer is too high or too low
from product.
2. Raise or lower tyer as necessary.
3. Poor bag tail
presentation.
3. Bag tail presentation from the exit of the bagger must be
flat and not folded over. If this is not achievable, contact
your Bagger manufacturer for assistance.
Two packages tied
together with one
ribbon.
1. Ribbon not dispensing
properly, causing
package recognition
system to abort on first
package.
1a. Check that ribbon is wound correctly on spool.
1b. Check that ribbon dispenser is working smoothly.
2. Package recognition
system ribbon roller is not
free to rotate. 2. Check roller and repair as necessary.
3. Ribbon dispense
proximity is not working.
3. Check proximity and connections. Repair as necessary.
4. Poor bag tail
presentation.
4. Bag tail presentation from the exit of the bagger must be
flat and not folded over. If this is not achievable, contact
your Bagger manufacturer for assistance.