TeraStation III iSCSI User Manual
48
Network
IP Address Settings
Click [Modify Settings] to
change settings.
*The LAN cable connected to
LAN port 2 should be set for
Ethernet 2.
DHCP
If a DHCP server is available, enable DHCP to assign IP addresses
automatically.
Primary IP Address
If not using DHCP, enter an IP address manually.
Subnet Mask
Set a subnet mask.
Default Gateway Address Specify the IP address if the default gateway if it exists.
Primary DNS Server
Specifies an IP address for the primary DNS server.
Secondary DNS Server
Specifies an IP address for the secondary DNS server.
Ethernet Frame Size
Click [Modify Settings] to
change settings.
*The LAN cable connected to
LAN port 2 should be set for
Ethernet 2.
Ethernet Frame Size
You can improve data transmission speed by increasing the maximum
amount of data that can be sent at once.
• [1518 bytes (Default)]
• [4102 bytes (Jumbo Frame)]
• [7422 bytes (Jumbo Frame)]
• [9694 bytes (Jumbo Frame)]
Port Trunking
Click [Modify Settings] to
change settings.
Port Trunking
Set this option to connect 2 Ethernet ports to the TeraStation. The
following settings are available:
• [Off]: Port trunking is not used.
• [Round-robin policy]: Sets a round-robin policy for fault tolerance
and load balancing.
• [Active-backup policy]: Sets an active-backup policy for fault
tolerance.
• [XOR policy]: Sets an XOR (exclusive-or) policy for fault tolerance and
load balancing.
• [Broadcast policy]: Sets a broadcast policy for fault tolerance.
• [Dynamic link aggregation]: Sets an IEEE 802.3ad dynamic link
aggregation policy.
• [Adaptive transmit load balancing (TLB)]: Sets a Transmit Load
Balancing (TLB) policy for fault tolerance and load balancing.
Содержание TeraStation III TS-IXL
Страница 65: ...KC A A BSMI CCC A...
