Buell XB 2010, Руководство по обслуживанию

Страница: 375 / 714

3. See Figure 4-9 . Attach ECM connectors [10] and [11].
Connect positive (+) battery cable first. If positive (+) cable
should contact ground with negative (-) cable connected,
the resulting sparks can cause a battery explosion, which
could result in death or serious injury. (00068a)
4. Connect battery positive cable (red) first, tightening to
60-70 in-lbs (6.8-7.9 Nm). See
1.16 BATTERY MAINTEN-
ANCE .
5. Connect negative battery cable, tightening to 60-70 in-lbs
(6.8-7.9 Nm).
NOTES
• The Throttle Position Sensor Zero Procedure should be
performed if the throttle position sensor or ECM have been
replaced or if the ECM has been recalibrated. See
4.5 THROTTLE POSITION SENSOR (TPS) .
• The throttle body has a throttle plate stop screw that is
preset at the factory and has tamper proof paint applied
to the head of the screw. Do NOT attempt to adjust this
screw. Tampering with this screw will require throttle body
replacement.
• If the ECM was replaced with a new component, it will be
necessary to download the correct calibration using D.T.
DIGITAL TECHNICIAN (Part No. HD-48650) and perform
the TPS zero procedure.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
6. Install seat.
sm00863c
Figure 4-9. Electronic Control Module (ECM): Ulysses
HOME
2010 XB Service: Fuel System 4-9