Buell XB 2010, Руководство по обслуживанию

Страница: 354 / 714

sm00182
Figure 3-121. Sprocket Shaft Seal Retaining Ring
3. See Figure 3-121 . Remove sprocket shaft oil seal retaining
ring.
4. See Figure 3-120 . Remove sprocket shaft oil seal (3) from
crankcase using SNAP-ON BODY DENT PULLER (Part
No. CJ114).
5. Remove outer thrust washer (4) next to sprocket shaft
bearing (6).
sm00183
Figure 3-122. Removing Sprocket Shaft Bearing Retaining
Ring
6. See Figure 3-122 . Remove sprocket shaft bearing retaining
ring from the inside of the left crankcase half.
sm00184
Figure 3-123. Direction of Bearing Removal From Left
Crankcase
NOTE
The bearing presses to the inside. There is a shoulder incor-
porated into the left crankcase half which allows the bearing
to be removed in one direction only.
7. See Figure 3-123 . Using CRANKCASE BEARING
REMOVER/INSTALLER WITH ADAPTER (Part No. B-
45655, HD-42720-2 and HD-46663) press sprocket shaft
bearing out of the left crankcase half.
PINION SHAFT BEARING
TOOL NAME PART NUMBER
END CAP HD-34902-7
BEARING RACE
REMOVER/INSTALLER HD-34902B
CLAW PULLER HD-95635-46
WEDGE ATTACHMENT HD-95637-46B
CRANKCASE MAIN BEARING LAP-
PING TOOL HD-96710-40D
CRANKCASE MAIN BEARING LAP HD-96718-87
General
See Figure 3-120 . The right side pinion shaft bearing consists
of an inner and outer race with rollers.
The inner race (11) is pressed onto the pinion shaft. The outer
race (14) is a pressed into the right crankcase half (15).
NOTE
Refer to Table 3-25 and Table 3-26 . If either inner or outer race
show wear, measure both races to confirm correct bearing fit.
Table 3-25. Pinion Shaft Bearing Service Wear Limits
MM IN. RACE
31.734 1.2496 Inner race OD
39.76 1.5656 Outer race ID
NOTE
Pinion shaft bearing selection at the factory, during engine
build, or replacement of crankcase set or flywheel assembly
HOME
3-86 2010 XB Service: Engine