Buell XB 2010, Руководство по обслуживанию

Страница: 376 / 714

4.5 THROTTLE POSITION SENSOR (TPS)
REMOVAL
1. Remove air cleaner cover. See 4.3 AIR CLEANER
ASSEMBLY .
2. Remove throttle body assembly. See 4.15 THROTTLE
BODY .
3. See Figure 4-10 . Disconnect throttle position sensor con-
nector [88].
4. See Figure 4-11 . Remove two screws and washers to
detach TP sensor.
INSTALLATION
1. See Figure 4-11 . Apply LOCTITE 222 (purple) to threads
of fasteners.
2. Install fastener into lower mounting hole of sensor prior to
installation.
3. Attach TP sensor with both fasteners and washers. Tighten
to 12-15 in-lbs (1.4-1.7 Nm).
4. Install throttle body. See 4.15 THROTTLE BODY .
NOTE
The Throttle Position Sensor Zero Procedure should be per-
formed if the throttle position sensor or ECM are replaced or
if the ECM has been recalibrated.
5. To zero the TPS:
a. Set the Run/Stop switch to the Run position.
b. Turn the ignition key to the On position.
c. With the engine off, rotate the throttle grip from closed
throttle position to wide-open throttle position and
back to closed position 3 times holding the throttle
grip against each stop for 1 full second.
d. Cycle the key off and back on. A properly calibrated
TPS sensor will indicate 3.7 to 4.2 degrees.
sm00244
Figure 4-10. Throttle Position Sensor Connector Location
sm00246
Figure 4-11. Throttle Position Sensor
HOME
4-10 2010 XB Service: Fuel System