BTS FREEEMG 300, Руководство пользователя

Страница: 54 / 120

52
BTS Bioengineering
BTS FREEEMG
acquisition protocol
Fitting the patient
Carefully prepare the skin of the subject in the area to be examined before
positioning the pre-gelled electrodes on the muscles.
Note that the condition of the skin where the electrodes are
applied influences the quality of the acquired signal.
Therefore you should pay careful attention to this phase in
preparing the subject.
Attach the probes, previously activated (see § ““Active” Button), to the
electrodes using the appropriate clips.
Thanks to the special hardware architecture of the probes and the
much reduced weight, normally no extra fixing is required.
If the analysis protocol being used requires it, proceed to the positioning
of the footswitches to the respective contact areas.
When FSWs are used, these are fixed to the skin of the subject used tape
or hyper-allergenic bi-adhesive tape.
Never apply the tape on the black membrane of the sensor,
removing the tape could cause the detachment of the membrane
making the switch unusable.