DEVICE MENU | PAGE 31 OF 47
3.3.2
APPLICATOR KIT REPLACEMENT WIZARD
If, after a certain time, the applicator stops generating shockwaves correctly, it is possible to change the applicator
kit, following the chapter
Procedure of worn-out tube and roller replacement
. Install this replaced kit according
to the displayed instructions.
Procedure of the applicator kit replacement on the device:
1. Connect the original applicator to the compressor.
2. Start the applicator kit replacement guide.
3. Now, disconnect the original applicator from the compressor and complete the replacement of the kit (see the
chapter
Procedure of worn-out tube and roller replacement)
4. After completion of the kit replacement connect the applicator back to the same channel of the compressor
unit.
5. Finish the guide.
6. The device has successfully installed the replaced kit.