Bryant 604D024, Руководство по установке

Страница: 5 / 30

5
1 2
3 4
A07216
DETAIL A
A05161
CORNER WEIGHTS (SMALL CABINET) CORNER WEIGHTS (LARGE CABINET)
Unit
024
030 036
Unit
042 048 060
lb kg
lb kg lb kg
lb kg lb kg lb kg
Total Weight 350 159
350 159 373 169
Total Weight 440 200 463 210 499 226
Corner
Weight 1
70 32
70 32 75 34
Corner
Weight 1
88 40 98 44 107 49
Corner
Weight 2
54 25
54 25 58 26
Corner
Weight 2
68 31 61 28 70 32
Corner
Weight 3
84 38
84 38 90 41
Corner
Weight 3
106 48 127 58 136 62
Corner
Weight 4
141 64
141 64 150 68
Corner
Weight 4
177 80 177 80 186 84
Fig. 4 -- Corner Weights
Prior to initial use, and at monthly intervals, all rigging brackets and
straps should be visually inspected for any damage, evidence of
wear, structural deformation, or cracks. Particular attention should
be paid to excessive wear at hoist hooking points and load support
areas. Brackets or straps showing any kind of wear in these areas
must not be used and should be discarded.
UNIT FALLING HAZARD
Failure to follow this warning could result in personal injury
or death.
Never stand beneath rigged units or lift over people.
!
WARNING
PROPERTY DAMAGE HAZARD
Failure to follow this warning could result in personal
injury/death or property damage.
Rigging brackets for one unit use only. When removing a
unit at the end of its useful life, use a new set of brackets.
!
WARNING
USE OF RIGGING BRACKET
Field Installation of Rigging Bracket (if not already installed)
1. Remove unit from shipping carton. Leave top shipping skid
on the unit for use as a spreader bar to prevent the rigging
straps from damaging the unit. If the skid is not available, use
a spreader bar of sufficient length to protect the unit from
damage.
2. Remove 4 screws in unit corner posts.
3. Attach each of the 4 metal rigging brackets under the panel
rain lip (See Fig. 4). Use the screws removed in step 2 above
to secure the brackets to the unit.
PROPERTY DAMAGE HAZARD
Failure to follow this warning could result in personal
injury/death or property damage.
Rigging bracket MUST be under the rain lip to provide
adequate lifting.
!
WARNING
PROPERTY DAMAGE HAZARD
Failure to follow this warning could result in personal
injury/death or property damage.
Do not strip screws when re--securing the unit. If a screw is
stripped, replace the stripped one with a larger diameter screw
(included). When straps are taut, the clevis should be a
minimum of 36 in. (914.4 mm) above the unit top cover.
!
WARNING
Rigging/Lifting of Unit
1. Bend top of brackets down approximately 30 degrees from
the corner posts.
2. Attach straps of equal length to the rigging brackets at
opposite ends of the unit. Be sure straps are rated to hold the
weight of the unit (See Fig. 4).
3. Attach a clevis of sufficient strength in the middle of the
straps. Adjust the clevis location to ensure unit is lifted level
with the ground.
4. Remove corner post screws and rigging brackets, then
re--install screws.
After the unit is placed on the roof curb or mounting pad, remove
the top crating.
604D