©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-1550 02-09-2009
32
OVERSPEED — COMMERCIAL UNITS ONLY
RESETTING THE OVERSPEED
If the overspeed is tripped during
installation or service operations, reset
the cam by rotating it back to its detent
position.
By by-passing the overspeed switch and
running up the drive unit, it is possible to
manually rotate the cam.
In the event of a failure which activates
the overspeed, it will be necessary to
remove the complete drive unit from the
rail, and to return the unit to the dealer
or manufacturer for diagnosis and repair
before putting the unit back into service.
align
looking at end of
carriage
OVERSPEED ALIGNMENT
Before installing the carriage, the over-
speed cam must be adjusted to line up
with the overspeed housing.
1. Looking at the end of the carriage,
align the white mark on the cam with
the white mark on the overspeed
housing.
2. Slide the carriage on the rail, making
sure not to alter the alignment.
OVERSPEED (COMMERCIAL)
6. Unplug the switch harness, and re-
move the grommet.
7. Slide the grommet onto the other
side of the swivel switch cover, and
reconnect the harness.
8. Reassemble the cover using the 2
screws.
9. Remove the seat hinge nut, and in-
stall the harness guide on the oppo-
site side.
10. Fasten the switch housing on the left
arm. Slide the trim over the harness
on the backside of the arm.
