17
©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-1550 02-09-2009
1. Connect the wires as shown to the
right.
2. Tuck the excess wires in the footrest
hanger just above the footrest switch
bracket, and below where the outer
mounting tube would sit.
3. While holding the wires in place, bring
the footrest close to the carriage, near
the pivot bolt, and tilt the footrest
slightly while raising it up and over the
bolt until it is engaged in the slot.
4. Tighten the bolt, then the (2) set
screws at the top of the footrest post
(see illustration below) to completely
secure the seat post.
pivot bolt
footrest switch
bracket
footrest
hanger
Safety switches are located on each side
of the footrest, and on each side of the
carriage.
The
footrest safety switches
will stop
the elevator if they contact an object as
the unit moves up/down the rail.
1. Confirm correct operation of the
foot-
rest safety switches by moving the
sliding tray (BOTH SIDES) while oper-
ating the elevator.
The
carriage
safety switches
(one on
each side of the carriage) stop the elevator
when the unit reaches the end of the rail.
1. Confirm correct operation of the
carriage safety switches by running
the elevator to the top and bottom of
the rail.
footrest
safety switch
outer
mounting
tube
INSTALLATION
FOOTREST ASSEMBLY-Residential and Commercial Units
DO NOT PINCH THE WIRES WHILE SLIDING
THE FOOTEST OVER THE BOLT.
SAFETY SWITCHES
-
Residential and Commercial Units
set screws
carriage safety switch
(one also located on other side)
footrest safety
switch
(one also
located on
other side)