©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-1550 02-09-2009
20
1. Remove the seat.
2. Remove the carriage from the rail.
3. To adjust the limit switches, remove
the covers and rotate the angle ad-
justment bracket weldment, if neces-
sary, to access the limit switches.
4. Loosen the limit switches using a
9/16" box wrench on the outside nut
and a 5/8" open end wrench on the
inside nut.
It may also be necessary to use a
pair of needle nose pliers
.
5. To access the limit switch on the motor
side, it may be necessary to remove
the charge contact assembly.
a. Remove wire tie on the charge
contact.
b. Slide the charge contact out of
the way, being careful to keep
wires connected
.
c. Remove the outer nut on the
limit switch.
d. Slide the limit switch out to
provide access to the inside nut
for adjustment.
e. Tighten and reinstall parts.
f. Replace covers.
g. Adjust the angle adjustment
bracket.
h. Replace unit on rail.
i. Test that the unit charges
correctly.
Make sure contacts make
solid contact with rail end
when carriage stops at top
or bottom of rail.
INSTALLATION
charge contact
limit switch adjustment
