Brüel & Kjær Vibro VIBROTEST 60, Техническая документация инструкция, Страница: 18 / 172

Introduction VIBROTEST 60
Page 14 of 168 C102 853.002 © VTEST60E July 2013 4.46ff
2.2 Module overview
The following documentation describes all available modules of
the VIBROTEST 60. In any individual case those modules
which correspond to the order acknow-ledgement are released.
Module Functions
Module 1.1
: Basic Module
Overall values for machine
evaluation
• Absolute bearing vibration
• Relative shaft vibration
• BCU / Bandpass (BP)
• Process values
• Manual entry
• Listing function
•
Speed measurement
Module 1.2 :
Extension
Module
Overall values for machine
evaluation
• Measurement vs. speed (f(n))
• Measurement vs. time (f(t))
Module 2.1:
Basic Module
Machine diagnosis
• FFT-Spectrum
Module 2.2:
Extension
Module
Machine diagnosis
• Envelope analysis (BCS / SED)
• Cepstrum
Module 3
Tracking analysis
• Free-running measurement
• Measurement vs. speed f(n) and time f(t)
(Run-up, Coast-down)
Module 5
Two-channel function
• Two-channel function
Module 6
Data-collector
single-channel measurement
Measurement module not
included
Following optional modules can be used in
Data-collector operation.
• Module 1.1 Basic Module
Overall values for machine evaluation
• Module 2.1 and 2.2
Machine diagnosis
• Module 8
CPB-Spectrum
Module 7
Field balancing
• 1-plane balancing
• 2-plane balancing
• 1-/2-plane balancing with Prognosis
• Polar-, component and unit mass correction
• On- / Off Adaptive mode
Module 8
CPB-spectrum
• CPB-spectrum