Brother Innov-is NX600, Руководство по обслуживанию

Страница: 119 / 214

3 - 43
Needle-presser module Modules
Assembly
3
Presser bar attachment
1. Attach the presser bar bushing
1
to the upper unit holder using the screw
1
.
2. Apply a small amount of Molykote Em30L to the presser bar clamp
2
.
3. Lubricate the end of the presser bar
3
with Sewing Lube.
4. Attach the presser bar
3
, presser bar clamp
2
, and presser spring
supporter
4
to the upper unit holder.
5. Hand start the screw
2
in the presser bar clamp
2
.
(Fully tighten after 4 - 13 "Presser bar height and parallel adjustment.")
*Key point
• Face the D cut in the presser bar to the left, and adjust the
length from the upper unit holder base plate to the end of the
presser bar
3
to approximately 50 mm.
Start movie clip (CD-ROM version only)
Apply Molykote EM30L grease to the sliding part
of the presser bar clamp assy. locking pin
Small amount
Lubricate the end of the presser bar with Sewing
Lube. Apply liberally to
the end
1
Torque
0.78 – 1.18 N·m
2
Torque
Hand tighten
S07
1
4
2
1
2
S07
3
*Rear view
Approx. 50 mm
S07
Taptite, Bind B
M 3X8
Color; Gold
Set Screw, Socket (CP)
M5X10
Color; Black
85.7
6.2
SPRING
XC2448***
4
T cam attachment
1. Apply a small amount of Molykote Em30L to the cam groove
1
and shaft
hole
2
of the T cam.
2. Attach the T cam
3
to the upper unit holder.
3. Apply a small amount of Molykote EML30L to the gear for the T cam
3
.
Start movie clip (CD-ROM version only)
Apply Molykote EM30L grease to the entire cam
groove in the T cam
Small amount
Apply Molykote EM30L grease to the shaft hole
in the T cam
Small amount
Apply Molykote EM30L grease to the entire
surface of the gear for the T cam
Small amount
1
3
2