Brother HL-3160CDW, Онлайн руководство пользователя

Страница: 189 / 319

Error Message Cause Action
Replace WT Box
It is time to replace the waste
toner box. Replace the waste toner box with a new one.
See
Related Information : Replace the Waste
Toner Box.
Self-Diagnostic The temperature of the fuser unit
does not rise to a specified
temperature within the specified
time.
Press and hold to turn the machine off,
wait a few seconds, and then turn it on again.
Leave the machine idle for 15 minutes with the
power on.
The fuser unit is too hot.
Short paper The length of the paper in the tray
is too short for the machine to
deliver it to the Face down output
tray. Open the back cover (Face up output tray) to
let the printed page exit onto the Face up
output tray. Remove the printed pages, and
then press
Go .
Size Error The paper size defined in the
printer driver is not supported by
the defined tray. Choose a paper size supported by the defined
tray.
Size Error DX The paper size specified in the
machine's paper size setting is not
available for automatic 2-sided
printing. Press Cancel (if required).
Load the correct size of paper in the tray and
set the tray for that paper size.
Choose a paper size supported by 2-sided
printing.
Paper size available for automatic 2-sided
printing is A4.
The paper in the tray is not the
correct size and is not available
for automatic 2-sided printing.
Size Mismatch The paper in the tray is not the
correct size. Load the correct size of paper in the tray and
set the size of paper for the tray. Press
Go .
Toner Error One or more toner cartridges are
not installed or not installed
correctly. Pull out the drum units. Remove all the toner
cartridges, and then put them back into the
drum units.
Toner Low: BK
Toner Low: C
Toner Low: M
Toner Low: Y
(BK=Black, C=Cyan,
M=Magenta, Y=Yellow.)
If the LCD displays this message,
you can still print. The toner
cartridge is near the end of its life. Order a new toner cartridge before the LCD
displays
Replace Toner
.
WT Box End Soon The waste toner box is almost full. Order a new waste toner box before the LCD
displays
Replace WT Box
.
HL-3190CDW
Error Message Cause Action
2-sided Disabled The back cover of the machine is
not closed completely. Close the back cover of the machine until it
locks in the closed position.
Access Denied The function you want to use is
restricted by Secure Function
Lock 3.0. Ask your administrator to check your Secure
Function Lock Settings.
Calibration Calibration failed.
• Press and hold down to turn the
machine off. Wait a few seconds, and then
turn it on again. Perform the colour
calibration again using the LCD.
• Install a new belt unit.
• If the problem continues, contact Brother
customer service or your local Brother
dealer.
185