Brother HL-2700CN Series, Руководство по обслуживанию

Страница: 40 / 377

III-2
CHAPTER III INSTALLATION
1. CONDITIONS REQUIRED FOR INSTALLATION
Any Laser beam printer is likely to be influenced by the environment of the set-up
location. If the printer is set-up in an inappropriate location, the printer may not perform
as expected. Therefore, the following factors should be taken into consideration before
deciding where to set-up the printer.
WARNING
This printer may have to be powered off by turning off the power switch or unplugged in
some cases. The power switch is located at the lower left of the left side cover PU.
The power cord is connected to the back of the printer. Set the printer so that the power
switch or cord can be easily accessible just in case.
1.1. Environmental Conditions
The printer should not be set up in the locations referred to in the following items (a)
through (d) which specify inappropriate locations for set-up.
(a) Where it is likely to receive direct sunlight or similar light. (For example, next to a
window)
(b) Where it is likely to suffer a big difference in temperature and humidity between the
maximum and minimum levels. (Normal operation environment is within 10 ° C ∼
32.5 ° C, 20 ∼ 80%RH and without any condensation.)
(c) Where it is likely to be in a draft of cold air from an air-conditioner or warm air from a
heater, or to receive direct radiant heat.
(d) Where it is likely to cause humid, dust, smoke, oil mist or ammonia gas.
(e) Where it is likely to use the ultrasonic humidifier.
(f) Where it is likely to have poor ventilation.
(g) Where it is likely to have unstable condition in terms of set-up table etc.
(h) Where it is likely to have poor set-up surface (skew greater than
± 1 ° ).