Brother 882-W33, Руководство по эксплуатации

Страница: 45 / 216

LOWER THREADING
Se
w
in
g Ba
sics
43
2
k
After bobbin winding is finished, cut the
thread and remove the bobbin.
■
If the Thread Becomes Tangled
Under the Bobbin Winder Seat
Refer to “If the Thread Becomes Tangled Under the
Bobbin Winder Seat” on page 185.
■
Using the Spool Pin
You can use the main spool pin to wind the bobbin
before sewing. You cannot use this spool pin to
wind the bobbin while sewing.
a
Turn the main power to ON and open the
top cover.
b
Align the groove in the bobbin with the
spring on the bobbin winder shaft, and set
the bobbin on the shaft.
a
Groove in the bobbin
b Spring on the shaft
c
Pivot the spool pin so that it angles upward.
Set the thread spool on the spool pin so that
the thread unwinds from the front of the
spool.
a
Spool pin
b Spool cap
c
Thread spool
d Spool felt
d
Push the spool cap onto the spool pin as far
as possible, then return the spool pin to its
original position.
e
While holding the thread with both hands,
pull the thread up from under the thread
guide plate.
a Thread guide plate
f
Pass the thread through the thread guide.
a Thread guide
IMPORTANT
• When removing the bobbin, do not pull on the
bobbin winder seat. Doing so could loosen or
remove the bobbin winder seat, and could
result in damage to the machine.
a
b
a
a