200747_1TB
6
Chimney Requirements
Please note Broseley Fires do not provide flue pipes, closure plates or any other
associated accessory.
Top Flue Outlet Only
The stove must be installed in accordance with current gas and buildings regulations
BS5871: Part1. The appliance can be installed in any adequate area suitable for solid
fuel fires and stoves. It can use a class 1, class 2 and pre-cast flue.
For pre-cast flue installations it is ESSENTIAL that a sealed connection is made into
the actual flue system (a void behind a closure plate is not permitted). Please refer to
the codes of best practice for further advice on pre-cast flues. Before you install the
stove, make sure the chimney flue outlet is correctly positioned to align with the flue
outlet on the stove and that the chimney is in good condition. If not, a chimney liner
must be installed or a suitable class II gas flue used. A draught is necessary to ensure
the products of combustion are fully evacuated.
Ideally it is recommended that the flue run is as straight as possible. The flue
must have a minimum vertical height of 3 metres to insure adequate draught.
You can have a maximum of four bends in the run, each bend must not exceed
45° and an additional metre of vertical flue should be provided for each bend.
Ideally you should have a minimum vertical section of 600mm before any bend
immediately off the top of the appliance, however it is permitted to use a 45°
bend straight off the appliance provided you have an adequate flue draft.
Prior to installation, the installer should insure that the flue is free from obstruction and
any dampers must be fixed in a permanently open position. Ensure the chimney is not
closed and that it has been swept and subsequently smoke tested.
Make sure that rain, birds or any foreign body cannot get into the chimney to cause
damage or blockage. This problem can normally be overcome by fitting an approved
gas cowl. It is essential for the effective running of your stove that the chimney draws
properly to allow the products of combustion to escape.
VENTILATION (GB ONLY)
The gas stove is rated at less than 7kw and therefore does not normally require
additional ventilation in the room (BS5871
– part II).
Flue Spigot Connection
Attach the supplied spigot to the top of the stove using the three M6x40 bolts and
washers provided.