200747_1TB
23
Operating the Stove
It is important to read these instructions thoroughly before lighting the stove.
The gas stove operates with a traditional permanent pilot light.
The knob for ignition and power control is located on the lower right hand side of
the stove, the indicator in the plate shows the knob position (Marked on knob)
The pilot light is located at the front left corner of the coal matrix.
If the Flame Supervision Device Actuating Flame (the pilot light) is extinguished by
intention or not, no attempt should be made to re-light
until 3 minutes have
elapsed.
IGNITING THE PILOT AND USING THE HIGH/LOW FUNCTION
1. Depress the control knob fully.
2. Whilst depressed, turn knob sharply 90 degrees anti-
clockwise to “pilot”
setting. Repeat until pilot light is visibly lit. You should feel some resistance
and hear a click. Repeat until the pilot lights.
3. Keep knob depressed at this point for 15-20 seconds.
4.
Upon releasing, turn the knob Anti-clockwise to select the low flame setting.
Turning the control further anti-clockwise you will be able to select the high
flame setting.
5.
From the high setting you can select low by turning the control knob
clockwise
EXTINGUISHING THE STOVE FULLY
1. From any heat setting or the permanent pilot, depress control knob and turn
clockwi
se to “OFF” position.
Important Note:
Should the glass door become broken or damaged in any way, turn your stove off
and do not attempt to re-light it. Contact your dealer for a replacement to be fitted
before relighting the appliance.
The glass used in this appliance is a ceramic type glass suitable for operation up to
750 Degrees, do not use any other types of glass in this appliance.
PLEASE EXPLAIN TO THE CUSTOMER THESE LIGHTING AND EXTINGUSIHING
PROCEDURES AND THAT IT IS NORMAL FOR THE STOVE TO GIVE OFF ODOURS
WHILST THE PAINT, SEALANT AND CAST IRON MATURES.