QmB Series IP40, IP65, IP65XP
Appendix B
CE Certification
B-3
Installation and Operation Manual
X-CM-QmB-eng
Part Number: 541B029AHG
June, 2008
Greek
Brooks Instrument
407 West Vine St. Hatfield, PA 19440
U.S.A.
English
Brooks Instrument
407 West Vine St.
Hatfield, PA 19440
U.S.A.
Subject
:
Addendum to the Instruction Manual.
Reference
:
CE certification of Mass Flow Equipment
Date
:
January-2000.
The Brooks (electric/electronic) equipment bearing the CE mark has been successfully tested to the regulations of the Electro
Magnetic Compatibility (EMC directive 89/336/EEC).
Special attention however is required when selecting the signal cable to be used with CE marked equipment.
Quality of the signal cable, cable glands and connectors:
Brooks supplies high quality cable(s) which meets the specifications for CE certification.
If you provide your own signal cable you should use a cable
which is overall completely screened with a 100% shield.
“D” or “Circular” type connectors used should be shielded with a metal shield. If applicable, metal cable glands must be used
providing cable screen clamping.
The cable screen should be connected to the metal shell or gland and shielded at both ends over 360 Degrees.
The shield should be terminated to a earth ground.
Card Edge Connectors are standard non-metallic. The cables used must be screened with 100% shield to comply with CE
certification.
The shield should be terminated to a earth ground.
For pin configuration : Please refer to the enclosed Instruction Manual.
