Brompton Brompton Electric Mk.1, Руководство пользователя

Страница: 7 / 52

WARNING
Many components on a bike are highly stressed, and with high mileage, heavy loads or hard riding, will
eventually reach the end of their design life; in particular, aluminium alloy has a limited fatigue life. Failure in
use can cause injury. You should check all load-bearing parts for any signs of damage, corrosion, or cracking,
and replace if necessary. Please visit an authorised Brompton Electric dealer for expert advice if you are
uncertain. Regular servicing and inspection of the bike by a Brompton Electric dealer is advised.
As with mechanical components, the electrical assist system including the battery and motor, is subject
to stress and wear. Different materials will react to stress fatigue and wear in different ways. If the design
life of the component has been exceeded it may not function correctly or fail suddenly. Any changes to the
appearance of colour of a part, or signs of cracking etc. could indicate the lifespan of the part has been
exceeded and it should be inspected and replaced by an authorised Brompton Electric Dealer.
The bike must not be subject to any modification, repair or replacement other than as authorised by Brompton
Bicycle Ltd, this includes but is not limited to the components listed below in the ‘replacement parts’ section.
The electrical system including the software should not be modified or tampered with, the hub-motor, control
module and battery should not be opened, tampered with or modified in any way.
The bike must be serviced at regular intervals by an authorised Brompton Electric Dealer. If the bike has
been subject to a crash or impact you should stop using the bike immediately and have the bike inspected
by a Brompton Electric dealer. Damaged components should be replaced and the bike thoroughly checked
before the bike is ridden again. Any deep scratches or gouges in the aluminium parts can severely weaken
the component and cause premature failure of the part.
We recommend that genuine Brompton parts are used for safety-critical components
REPLACEMENT PARTS
The following parts of your Brompton Electric bike should only be replaced with genuine Brompton Electric
parts, by an authorised Brompton Electric dealer:
• Front wheel/motor
• Bottom bracket
• Front battery connector/mount
• Charger
• Electric system cabling
• Battery pack
• Brake pads
• Braking system components
• Luggage frame
• Suspension block
• Fork
• Mainframe
• Handlebar stem
• Rear frame
• Cranks
• Chainring
• Pedals
• Hinge clamp plates
Only Genuine Brompton Electric parts should be used for safety-critical components. Using replacement
parts other than those specified as original equipment on the bike may cause problems with the function of
the bike or make the electric bike unsafe to use
.
Changing the Drivetrain components, including the cranks, chainring and pedals will affect the performance
of the electrical assist system, such changes should only be made by an authorised Brompton Electric dealer.
If the Brompton Electric is modified in any way it may not then conform to the relevant safety standards.
Using the bike in a modified state may be dangerous and could cause injury and damage to property.
7