ENGLISH
OPERATION MANUAL
BRITEQ
®
7/19
BTX-HAWK
[Stage Hung]:
Fixture
is fixed upside-down on the ceiling of a stage
. The spot is mainly projecting
towards the audience in front of the stage. [PAN] movement angle (left to right to left):160°. [TILT]
movement angle: 90° (vertically, front 75°; back 15°)
Once the right mode is shown on the display, press the [ENTER] button to confirm.
[SlaveMode]
Used to make the slave unit work in opposite to the master or to work in complete sync.
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button: the values can be changed
Use ▲/▼ buttons to select the desired mode:
Slave 1:
the slave operates in complete sync with the master.
Slave 2:
the slave operates in the opposite mode as compared with the master.
Once the correct option shows on the display, press the [ENTER] button to confirm.
[FOCUS Set]
Used to help you adjusting the focus of the gobos while the fixture is used in standalone or
master/slave mode.
You can set the focus of the gobos in different directions. While working in auto/audio mode the fixture will
continuously try to keep the gobos sharp in the different directions. Please note that this is not always
possible, so the gobos will not always be perfectly sharp.
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Once you press the [ENTER] button the focus adjustment starts: for each position
use the ▲/▼ buttons to
adjust the sharpness of the projected gobo.
Focus 1:
the beam points upward,
use the ▲/▼ buttons to adjust the sharpness of the projected
gobo. Press [ENTER] to go to the following position.
Focus 2:
the beam is horizontal and projects the gobo behind the unit,
use the ▲/▼ buttons to adjust
the sharpness of the projected gobo. Press [ENTER] to go to the following position.
Focus 3:
the beam turns 90° clockwise,
use the ▲/▼ buttons to adjust the sharpness of the projected
gobo. Press [ENTER] to go to the following position.
Focus 4:
the beam turns 90° clockwise,
use the ▲/▼ buttons to adjust the sharpness of the projected
gobo. Press [ENTER] to go to the following position.
Focus 5:
the beam turns 90° clockwise,
use the ▲/▼ buttons to adjust the sharpness of the projected
gobo.
Press [ENTER] to stop the focus adjustment and save the focus parameters for the different positions.
Remark:
if the audio or 5MSL modes are used, you have to use the [FOCUS Set] procedure each time the
projector is used in a different location. No need to use this function when the projector is controlled via full
DMX-control.
[SET CONFIG > FIXTURE Set]
–
Used to configure different parameters if the projector.
[DIM Curve]
Used to set the dimmer curve of the master dimmer.
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button: the values can be changed
Use
▲/▼ buttons to selected the desired curve:
Once you have the desired curve, press the [ENTER] button to save it.
[TILT Invert]
Used to select if the TILT movements are inverted or not.
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button: the values can be changed
Use
▲/▼ buttons to toggle between [ON] and [OFF].
