ENGLISH
OPERATION MANUAL
BRITEQ
®
3/19
BTX-HAWK
Important:
Never look directly into the light source! Don’t use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
1. COOLING FANS:
during its operation the projector produces heat that must be dissipated. The fans
inside the projector must be able to evacuate the heat in the most effective way. Therefore is it very
important not to cover any of the ventilation openings as this may result in overheating.
2. MAINS INPUT:
equipped with original Neutrik PowerCON
®
. Connect the supplied mains cable or any
PowerCon
®
extension cable here.
3. MAINS OUTPUT:
used to daisy chain the power to several other projectors. Always pay attention to the
maximum load while adding projectors! Special Multi cables (PowerCON
®
+ DMX XLR-cables are
optionally available: see our website!)
4. MAINS FUSE:
protects the unit in case of electrical problems, always use the prescribed fuse!
5. DMX IN:
both 3pin and 5pin inputs are available to daisy chain the projector with other units that will be
controlled by a DMX-controller. The DMX-inputs are also used to update the firmware of the projector,
see the upgrade instructions on our website.
6. DMX OUT:
both 3pin and 5pin outputs are available to daisy chain the projector with other units that will
be controlled by a DMX-controller.
7. W-DMX DONGLE INPUT:
this USB-input can be used to connect an (optionally available) wireless DMX-
dongle. With this dongle you can control the projector via wireless DMX.
8. [MENU] buttons:
used to browse the different options of the setup menu.
MENU/ESC. Button:
has several functions:
Enter the SETUP-menu:
press shortly.
Enter the SETUP-menu while the display lock function is active:
press during 3s.
Go 1 level up in the SETUP-menu:
press shortly to go 1 level up.
Leave the SETUP-menu:
press several times until the standard display is shown.
◄/►Buttons:
mainly used to navigate in the SETUP-menu
. The ►button is also used to rotate the
display over 180° (upsidedown).
