ENGLISH
OPERATION MANUAL
BRITEQ
®
11/19
BTX-HAWK
Press the [ENTER] button to confirm.
[INFORMATION > LED Temp.]
–
Shows the actual temperature of the LEDs.
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button: the LED temperature is shown.
[INFORMATION > ERROR info]
–
Shows information about eventual errors.
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button:
No errors:
display shows [NONE]
Errors to report:
the error will be shown on the display so you can take action.
[INFORMATION > DMX values]
–
Shows the function and DMX-value for the last used DMX channel: used for problem solving
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button: the display shows the function and DMX-value of the last used channel.
Use a DMX-controller to control the projector: every time a value on one of the DMX-channels was
changed, the information will be shown on the display.
[INFORMATION > Model Name]
–
Shows the name of the projector.
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button: the display shows [BTX-HAWK].
[INFORMATION > Firmware V.]
–
Shows the current firmware version in the projector.
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button: the display shows the firmware versions of the different processors in the
projector: 1U01, 2U01, 3U01
Note:
The firmware of this unit can be upgraded using a special upgrade tool with Windows
®
software.
(separately available from Briteq). More information about this can be found in the user manual of the
upgrade tool and / or our website: www.briteq-lighting.com
[TEST/RESET > AUTO TEST]
–
Used to start the automatic test function: all functions will be tested.
Important: use the projector in STANDALONE (NO DMX connection)
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button: the projector starts an automatic AUTOTEST program until you stop it.
Press the [MENU] button to stop the program.
[TEST/RESET > RESET Menu ]
–
Used to reset certain functions of the projector.
Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button: the display shows [Reset ALL]
Press the [ENTER] button again to start resetting ALL functions or press the
◄/► buttons to select the
desired function to reset and press [ENTER] to confirm.
CALIBRATION MENU
This is a hidden menu where you can fine-tune the offset of several functions. To access this menu do as
follows: press the [ENTER] button for about 3seconds while you are in the SETUP menu (any option, not
important). Now the calibration menu shows up:
[Reset JOB]
Used to reset the [Last JOB] timer.
Press the ◄/► buttons until the desired function is showing on the display.
Press the [ENTER] button: the values can be changed
