BRISTELL S-LSA, Руководство по техническому обслуживанию и инспекции

Страница: 47 / 201

4. CHAPTER - WING
Document: SLSA-MIP-5-4-0-US Date of Issue: 05/2016 Revision: -
4-7
4.3.5 Aileron removal
Type of maintenance: heavy
Authorization to perform:
LSA mechanic or A&P mechanic (Airframe and Power plant)
Tools needed:

wrench size 7/16 in

cutting pliers
Removal of the aileron according to the following procedure:
Disconnect the control rod with control lever.
Remove the cover (1) from the hole (2) for access to trim tab actuator (6) on left aileron
(see Fig. 6-9).
Disconnect (on right aileron) trim tab actuator wires (3) (Fig. 6-9).
Remove piano hinge pin.
Remove the aileron from the wing.
Store the removed aileron on a safe place so that it cannot be damaged.
4.3.6 Aileron installation
Type of maintenance: heavy
Authorization to perform:
LSA mechanic or A&P mechanic (Airframe and Power plant)
Tools needed:

wrench size 7/16 in

pliers
Install the wing flap according to the following procedure:
Set the aileron on the wing in to the piano hinge.
Insert trim tab actuator wires (3) (see Fig. 6-9) going out from wing to the aileron.
Insert piano hinge pin.
Connect the control rod with aileron control lever.
Connect trim tab actuator wires (3) on the left aileron (see Fig. 6-9).
Close the access hole (2) with cover.
Perform check of the trim tab operation (see 6.4.3.5), check aileron deflection (see
6.4.3.1), adjust if needed (see 6.4.4.1).
4.4 Check / Adjustment
No procedures included.
4.5 Exchanges / Service information
No procedures included.