BRISTELL S-LSA, Руководство по техническому обслуживанию и инспекции

Страница: 135 / 201

10.CHAPTER
– POWER UNIT
Document: SLSA-MIP-5-4-0-US Date of Issue: 05/2016 Revision: -
10-29
10.5.2.3 Refilling cooling liquid
Refill cooling liquid into the expansion tank in the engine compartment. In addition to this
there is an overflow bottle which collects cooling liquid in case of engine overheating and is
attached to the firewall.
10.5.3 Exchange / Check of oil filter
Refer to the Rotax engine Maintenance Manual Chapter 12
–00–00 para 5.
NOTE
Carry out at every oil exchange.
Remove the oil filter.
Remove the filter insert, cut of the upper and the lower lid of the insert. Remove the
middle part of the insert, disassemble and check for metal chips, foreign corpuscles and
contamination.
CAUTION
If you detect an increased quantity of metal particles (brass or bronze chips or bearing
abrasive), find out the reason and eliminate it.
Install the new oil filter. Slightly lubricate the sealing ring of the new filter with engine oil
and tighten it up manually by a normal force.
10.5.4 Exchange / Check of air filter
Remove the hose fastener and the bracket attaching the air filter to the left side lower
engine cowling and remove the air filter.
Inspect the air filter and if contaminated, clean it according to instructions in the Rotax
engine Maintenance manual Chapter 12
–00–00 para 2.4.
Attach the cleaned or the new filter to the hole on the left side of lower engine cowling
by means of the bracket and hose fastener.
Fig. 10-20
Air filter installation on the lower cowling