Document: SLSA-MIP-5-4-0-US
Date of Issue: 05/2016
Revision: -
9-8
9.5
Exchanges / Service information
9.5.1
Fuel tank filling
CAUTION
When filling fuel in the airplane, use only approved kinds of fuel mentioned in this Manual,
par. 10.2.1.3, or in the POH Chapter 2,
or in Rotax engine Operator’s Manual–Section 10.2.2
and 13 or Service Instruction SI
–912–016.
9.5.1.1
Safety instructions for filling fuel into the airplane tanks
The fuel tanks can be filed with fuel only by persons who are fully instructed and
familiarized with safety instructions.
during rain and storm
in a closed space
when the engine is operating or with electric system switched on
A person filling the fuel tank must not be wearing polyester clothing or any clothing from
a material which creates static electricity.
It is prohibited to smoke or handle with open fire.
9.5.1.2
Procedure of fuel tank filing
Ground the airplane. The airplane ground point is located on the nose landing gear leg.
Open the fuel tank filler cap.
Fill necessary quantity of fuel.
CAUTION
When filling fuel into the airplane, avoid the contact of fuel with the airplane surface
– it would
cause damage on surface treatment of the airplane.
When the airplane is filled with fuel, wipe the filler neck of the rest of fuel and close the
fuel neck filler cap.
Remove conductive interconnection between the filling device and the airplane.
Drain the fuel tank.
9.5.2
Draining fuel system
Perform draining the fuel tanks and gascolator after every filling the tank with fuel before the
first flight of the day. The fuel tank draining points are on bottom side of the wings and on the
firewall.
9.5.2.1
Draining procedure
Open the drain valve by pressing up.
Drain required quantity of fuel.
NOTE
Draining serves for elimination of impurities and sediments from fuel. Drain so long unless
clean fuel flows from the drain valve.
Close the drain valve by releasing pressure.
Содержание S-LSA
