Briggs & Stratton 5 HP, Руководство по устранению неполадок и ремонту

Страница: 58 / 76

56
2. Press in until plug is flat. Do not cave in plug.
3. After plug is installed, seal outside edge of plug with
fingernail polish or non-hardening sealant.
Install Choke Shaft
1. Install choke shaft
(Figure 104)
and felt washer
. Rotate choke shaft until lever is as shown
.
2. Insert and center choke plate in slot of choke
shaft, with dimples as shown.
Install Throttle Shaft
1. Install throttle shaft
(Figure 105)
and foam washer
.
2. Turn shaft until flat is facing out.
3. Lay throttle plate on shaft with numbers facing out
and install screw
.
Install Inlet Needle and Float
1. Install inlet needle
(Figure 106)
to float and
install assembly to carburetor body.
2. Insert float hinge pin and center pin between float
pin bosses. Float height is non-adjustable.
3. Install rubber gasket on carburetor and lay float bowl
on body.
4. Place fiber washer over main jet and install
main jet. Torque nut to 50 in. lbs. (6 Nm) .
1 2
3
4 5
4
1
3
2
4
3
2 1
Section 5 • Assembly
5 HP Outboard • Troubleshooting & Repair Manual
5
Figure 104 — Choke Shaft
Figure 105 — Throttle Shaft
Figure 106 — Assemble Carburetor
4
1
3
2
1
3
1
2
3
4
5
4
2